Used Raptor Bed Liner (link below) – goes on very easily with the supplied air gun and comes off the fiberglass with acetone… 11-24-20 -Greg Roselli

https://smile.amazon.com/gp/product/B01CKE7B1E

Fitting it in is like a bar puzzle but it’s doable. Access panel link below. Waiting till the very last minute to attach permanently… 11-24-20 -Greg Roselli

https://www.circletracksupply.com/aluminum-access-panels.html

Tail lights & headlights, cleaned up the amp wiring, mounted the passenger seat and installed Simpson 5-point belts. Jeep Wrangler headlights seem to get the job done here according to other builders. 11-24-2020 -Greg Roselli

https://smile.amazon.com/gp/product/B01MTXNED5

https://smile.amazon.com/Simpson-Racing-29073BK-Pull-Down-Individual/dp/B0006HLT0M

Been a slow year but I’m back at it… Radio equipment and rearview mirror links below, we’ll see if it’s loud enough while the engine is on. Continuing prep work to put body on…  -Greg Roselli 4-27-20

https://smile.amazon.com/gp/product/B00J863EI2/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

https://smile.amazon.com/gp/product/B004VSTYI6/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

https://smile.amazon.com/gp/product/B004VBK860/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

https://smile.amazon.com/gp/product/B004T0WFVE/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Left the nest to get the AC charged and car aligned while it was still open. Rolling chassis is officially complete. Thanks to  https://www.artiesgarage.com/   Still a lot of work ahead….         -Greg Roselli  5-2-19

Cut holes in dash for remaining gauges, switches and AC vents. Installed Russ Thompson turn signal system (http://www.norcal-cobras.com/store/russ_garage/t65/t65tss.html). Completed wiring. 2nd test run.   April 15, 2019   -Greg Roselli 

It’s possible I forgot to post here for 5 months.  Remaining AC work, trinary safety switch, condenser and controls. Dash board cut and placement, initial gauge wiring. Details in photo comments.  

Astro rivnut tool https://smile.amazon.com/gp/product/B003TODXQW/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

FFR Gauges  http://www.factoryfiveparts.com/60311-type-65-coupe-gps-gauge-set-mph/

December 3,  2018   – Greg Roselli

Remaining AC:

Dashboard/Gauges:

 

Routing the AC hoses, part 1. Had to buy additional Vintage Air Beadlock Heater Fittings and and a Mastercool Manual A/C Hose Crimper on amazon (https://smile.amazon.com/gp/product/B000WBQ4U2/ref=oh_aui_detailpage_o09_s04?ie=UTF8&psc=1). Also had a special guest in the workshop.   June 24, 2018    -Greg Roselli 

Applied LizardSkin Ceramic Thermal Insulation Coating (https://www.lizardskin.com/car-ceramic-insulation.html) to the interior with a 4″ roller vs. a spray. Mounted AC condenser and began install of Vintage Air Mini Space Saver AC/Heat/Defrost unit (https://www.vintageair.com/)    May 20, 2018   -Greg Roselli

Back at it after a few months off. Remaining Damplifier installed and began LizardSkin application   -April 30, 2018   Greg Roselli